Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2002

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

bolting on a turbo??

posted by  TheHunch on  Sun Dec 1 17:09 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

It may be possible to find a complete b21ft and just add everything to your block, although i'm not sure if the lower compression ratio on the turbo was achieved through the pistons or the head. If it was the pistons you could use a thicker head gasket to lower it. You would also have to tap the block for an oil feed to the turbo. Good luck. Adam.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New bolting on a turbo?? [200][1986]
posted by  Gandolf the Grey  on Sun Dec 1 13:10 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.