Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

What Do I Do Now? ECT Sensor 200 1990

There are two engine coolant temp. sensors? Well, I replaced the one under the 3rd intake manifold. I could tell if the female end of the connector was clean or not, but obviously the new sensor was clean. I checked the 700/900 FAQ section and found nothing for this. I will check the wiring, but if it brings the CEL light on again... is it going to hurt driving it? Should I replace the sensor again?

Should I disconnect the battery and see if that permanently rests the code?

Thanks a million for the response and I hope some new information, too.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New What Do I Do Now? ECT Sensor [200][1990]
posted by  dazsa  on Thu Jan 2 13:47 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.