Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2019 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Transfer Pump Replacement 200 1981

posted by  TheHunch on  Mon Jan 20 12:19 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I managed to get the bung nut back on (got it off with a screwdriver and hammer but couldn't get it back on) with a ball joint separator and an allen wrench. You have to find the correct size allen wrench (or any sort of little medal rod that is aprox. teh same length) that will fit between two of the inner notches and the wires. Then take the balljoint separator and place a prong on each side of the allen wrench and use a cresent wrench to turn the separator. If you have autozone where you live you can rent the separator from them. Good luck. Adam.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Transfer Pump Replacement [200][1981]
posted by  DougC  on Mon Jan 20 04:23 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.