Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2005 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Door seals 140-160

You probably stretched it just slightly as you worked it around the door, causing it to come up a bit long. I would be reluctant to cut it shorter in fear that it would pull back over time and leave a void. If it fit originally, it should fit again. If anything, rubber generally shrinks with age. I would pull the last couple of feet loose, make sure the ends butt together, and then start tucking it back into the track starting at the end and work back toward the point where you stopped pulling it out. Make sense??? 1 inch really isn't much to have to re-correct for. Can you just slide it in the track without actually pulling it out? Unless you have a particularly difficult time working it into the track, or it wants to fall out afterward, I wouldn't put any soap or cement on it.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Door seals [140-160]
posted by  blackjackmc  on Mon May 19 10:25 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.