Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Hinge question 200

posted by  B.C. on  Fri Jun 27 21:36 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 28 22:28 CST 2012
[RELATED]

I would go the boneyard route. And let them pull the part, you watch. My 1986 240 hinges are like the earlier models in that they have a fitting for greasing the hinge pin. My 1988 has not no fitting. Greasing takes a special tip, not a Zerk fitting, and a lot of pressure (they are usually clogged) but the hinge is way better lubed that way.

Check with a nearby body shop for a quote on the job - you bring the hinge. Those doors are quite heavy and a PITA to adjust properly.

Good Luck,

Bob

:>)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hinge question [200]
posted by  rockwellmusic  on Fri Jun 27 15:24 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.