Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

'89 740 Barke Line problem--Help 700

posted by  david hunter on  Mon Sep 1 09:23 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 30 22:10 CST 2014
[RELATED]

It can be difficult to get the nuts started even if the threads are correct and in perfect condition. It is especially difficult if the lines are not in good alignmnent with the master. Try tweaking the lines to get them into alignment, try jiggling as you turn the nut. Very judicious use of a wrench may be needed to get them started. Perhaps loosening of the master mounting nuts to allow it to move around a bit may help. Can't advise re thread specs but I would be surprised if they are not a match.
--
David Hunter






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New '89 740 Barke Line problem--Help [700]
posted by  pawdrip  on Mon Sep 1 08:40 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.