Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2008 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Test fixture for setting air mass sensor 700 1987

posted by  SlickV70 on  Mon Oct 13 06:11 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Question: How to build a test fixture for adjusting air mass sensor after replacing the Bosch oxygen sensor.

I recently watched my mechanic use a simple LED tester (with 2 wires) for setting the idle fuel mixture on my 87 740 turbo. He connected one test lead to the green wire on the test plug near the air filter box, and connected the other test lead to ground.

He then adjusted the air mass sensor until the on/off cycle on the test light was even (50/50). Sounds easy, eh?

My question, how can I build such a test fixture? It looks like I would use an LED (from Radio Shack) and maybe a series resistor. Any tips for getting the plans for this rig or where to buy one at a reasonable cost?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Test fixture for setting air mass sensor [700][1987]
posted by  SlickV70  on Mon Oct 13 06:11 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.