I don't have a picture but I recently got a gate from eBay. The mounting points are on the upper window sill, there are removeable rectangles just above the rear seat on both sides. Upon removing these plastic pieces you will find a threaded hole into which a mounting plate that should be included with the gate. I mounted mine with the holes rearward and the outer ends of the guard curving forward. This way when you swing it up rearward it follows the curve of the headliner. The lower hook can go on the seat back and release by swinging the seat a little bit forward. The upper hook can go on the underside of the window upper sill. These can all be made snug enough that there is no rattle. You could also cut holes in the plastic rectangles and replace them for a neater look. Hope this helps