Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2001

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

replacing Voltage regulator brushes

posted by  TONY H on  Mon Oct 20 05:24 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 16:39 CST 2014
[RELATED]

I cut the small brush wire even with the crimp and filed it flat. I then took a small drill and drilled down to remove most of the old Brush wire. Heated it witha solder Iron and useda small pick to open up the crimp further. It gave me a hole big enough to feed the new lead through.
I didn't even know Volvo had the other kind with the Terminal.
--
'75 Jeep CJ5 345Hp ChevyPwr and two motorcycles: it wasn't Volvos safety , it was Longevity that sold me






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New replacing Voltage regulator brushes
posted by  runwld2 subscriber  on Mon Oct 20 03:47 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.