Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

wheel question 200

posted by  trafty on  Sat Dec 6 15:00 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jul 27 13:31 CST 2007
[RELATED]

this morning i mounted a used set of corona wheels with snow tires. two of the wheels had the hole for the "pin" that is attached to the rotor, the other two did not. so, i took the rear rotor "pins" out, 10mm, and covered the holes with duct tape because i didn't know what to do; it was 15 degrees and windy with an impending storm blowing in. i mounted the rear wheels like this and mounted the front with the pins intact.

how come one pair of the corona's had the holes for the pins and the others didn't?

is the duct tape cover as ridiculous as it sounds?

thanks for the help.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New wheel question [200]
posted by  trafty  on Sat Dec 6 15:00 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.