Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Brake replacement question 200 1989

posted by  Bean on  Mon Mar 1 05:24 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Aug 30 03:53 CST 2010
[RELATED]

My only aftermarket supplier has been FCP Groton, sorry I can't offer any other recommendations...

I would not recommend using any used parts for a brake job.

If you aren't going to use a pressure bleeder (EZBleed, Motive PowerBleeder) to bleed the brakes then I highly recommend you also get a master cylinder. If you over extend the MC while pumping the brakes, the internal seals can be damaged from overextending the shaft/seals into rusted areas that may be formed in the cylinder...this is very common with the 240 series of your vintage. It just happened to me after changing my rear calipers on my '87 245 and I was using the PowerBleeder. Stranded me at my parent's house for an overnighter (I live 90min from them) until I could source a MC to finish the job.

If you don't need the MC then you can return it, the extra cost of shipping it back is less than the piece of mind of planning for disaster. (in my opinion)

Good luck
--
'80 242GT 91k, '94 945T 110k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Brake replacement question [200][1989]
posted by  uc4me  on Mon Mar 1 02:51 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.