Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

No start unless pumps jumped 200

uid 18083's pic
posted by  lucid on  Sun Mar 21 05:12 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 12:31 CST 2014
[RELATED]

Colin's linked 700 CI diagram is logically accurate, but 240 fuses are different.

Power to pick the FI relay coil is Key On 12V — via fuse 13 to relay terminal 15 BL/R wire, but this input must also be "anded" with ignition pulses on the W/R wire at terminal 31b. The relay ground is hard-wired as shown.

Relay transfer voltage comes from Fuse 7 to terminal 30 (Red wire), and goes out 87 (Y/R) to the Main pump (and fuse 5 input). The 87b (BL wire) goes to Aux Air Valve and WUR heaters, and also picks the Lambda relay out on the left fender rail.

I'd make sure the coil primary connections are really clean, especially the W/R on Coil #1. Same thing goes for Fuse 13 and the fuse holder contacts.
--
Bruce Young
'93 940-NA (current) — 240s (one V8) — 140s — 122s — since '63.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New No start unless pumps jumped [200]
posted by  RCox  on Sat Mar 20 14:29 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.