Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2022 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Initial start 700 1990

posted by  Jippi on  Wed May 19 09:59 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Feb 22 04:25 CST 2007
[RELATED]

i have a 1990 745 Gle 16v. the t-belt snapped and broke valves and i finally got it into one piece and reassembled the engine but the motor wont start. when i went to lineup the lower timimg marks i lined it up to the mark on the outer plate(the one between the main t-belt pulley and the drive belt pulley) when i looked the balance shaft belt pulley attached to the crankshaft had 2 marks complete opposite of each other. which mark do i go by? and is the distrubutor's mounting position fixed and cant get reversed? right now the car only cranks but doesnt start. is there a special procedure for 16 v motors?
thanks in advance
jippi






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Initial start [700][1990]
posted by  Jippi  on Wed May 19 09:59 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.