Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2014

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Really Need help on Kick Down Cable replacement - 1988 240GL

posted by  nmtrout on  Sat May 22 14:51 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Did finish the job - almost. Still cannot get the friction-Fit end to go in. Tried almost everything - no luck.

Question is what risks am I running by not seating the end completely? I did try prying, pulling, etc and could not get it in. I also tried to pry it out (did not try too hard) - it seems stuck in there pretty well.

My daughter did drive it around the neighborhood (she couldn't wait) and everything seemed fine as far as leaks are concerned - any thoughts?

Really appreciate your (and everyones) input. Once again I will comment that if someone reading this decides to do this LOWER THE EXHAUST.

Thanks - Ted (and daughter Nicole) in Albuquerque






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Really Need help on Kick Down Cable replacement - 1988 240GL
posted by  nmtrout  on Sat May 22 08:37 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.