it says pin 13, you say no. which pin is it. I've looked in the swedishbricks faq and there is nothing on this.

this info is from the 700/900 FAQ

"With the control unit connected, connect a voltmeter across LH ECU terminals 13 and 5 (ground). This unit is in the passenger side footwell, under the plastic cover. Remove the cover of the large electrical connector to access the backs of the pins for the test. Turn the ignition switch ON.

At 68F (20C) the voltage should be 2.0 +/-.5v volts.
At 104F(40C) the voltage should be 1.2 +/- .3volts
At 176F (80C) the voltage should be .5 +/- .2volts.
The resistance values between ECU pins 13 and 5, or between each of the pins on the sensor and ground, are (by eye from the chart):
32F (0C)-- about 6000 ohms within a range of +/- 10%
68F(20C) -- about 2300 ohms "
104F(40C) -- about 1300 ohms "
140F(60C) -- about 600 ohms "
176F(80C) -- about 300 ohms "
212F -- about 190 ohms "


Also, i wired a lead from the 1.5v(not the 12v one) battery just to make sure there was contact.