Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

No start 200 1984

uid 18083's pic
posted by  lucid on  Mon Jun 7 14:31 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 12:31 CST 2014
[RELATED]

1- Check the 25 amp blade fuse near the coil

2- Take both coil primary wires off and on a few times

3- Check fuse 13 very carefully (energizes Fuel Relay when ECU sees spark is OK)

4- Jumper !2V from fuse 6 or 7 to Fuse 5, using LEFT side contacts. (Bypasses Fuel Relay) Both pumps should run immediately.

Try starting with pumps running. Should start if you have spark.

Unless spark is at the wrong time. Maybe the timing belt spit some cogs during all the excitement. Get crank pulley on 0°, then pull dist cap and see if the rotor is about 1/4" past (CW rotation) the little notch in the dist body. Rotor "Past" the mark is due to the initial 12° advance.
--
Bruce Young
'93 940-NA (current) — 240s (one V8) — 140s — 122s — since '63.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New No start [200][1984]
posted by  someone claiming to be Don  on Mon Jun 7 12:47 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.