Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Ignition Module Plug Question 200

posted by  gms on  Fri Jul 16 06:02 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Sep 11 18:35 CST 2013
[RELATED]

Do a search on the board for "ignition sleeve" for the P/N. The connectors end up kind of sloppy after being removed, the sleeves fit on over the pins on one side to increase the OD. The catch: the sleeves are now up to around $3 a pop from the dealer.

I put three of them on the other side of the harness, on the connector to the dist hall effect device, and that cured some horrendous engine miss gremlins I had.

I got some advice awhile back to be wary of the sleeves on the ICU side, because they end up sticking inside the ICU and are a bitch to remove. This fellow recommended blobbing some dielectric grease in there, and if the connector was shot, spring $100 for a new harness...

Greg






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ignition Module Plug Question [200]
posted by  Cliff M  on Thu Jul 15 17:38 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.