Volvo RWD S90-V90 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2002 S90-V90 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to replace S90 Brakes? S90-V90

posted by  96854 on  Thu Aug 26 09:46 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Thanks, sounds straight forward just like the 850s. I also checked the FAQ section in this forum and it mentioned shims. Can you confirm that there are SHIMS in both the front and rear? Do they go on both in-outboard of the pads?

On the other hand, I'm surprised to hear the previous poster say that PBR pads and Brembo replacement rotors didn't work well. I will make sure to keep it OEM up front.

On my 850t, I have stainless steel braided lines all around, EBC green pads and xdrilled rotors in front; same in the rear except for PBR pads. Braking is firmer and bites much harder than stock.

I know the brake pad issue has probably been discussed too many times, so no need to reignite this. Just want to share my experience on the setup mentioned above. Stock brakes will be good enough for my mother's S90.

Again, are there shims on the S90 brakes? THANKS!!!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to replace S90 Brakes? [S90-V90]
posted by  96854  on Thu Aug 26 04:11 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.