Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

additional information............ 200 1980

posted by  timc on  Tue Dec 21 04:32 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jul 22 16:24 CST 2014
[RELATED]

Didn't realize I didn't log in to post that first one.

Now you can EM me thru the board.

Also, these are the very narrow belt mouldings. I think some of the 240's had belt mouldings about 1" or so wide. These are quite narrow, under 1/2 ". They run from the front of the fenders, just above the door handle, clear back around the trunk.


One dealer shows P/N 1247708, at $.084 apiece. Says this molding is 12 mm wide. That sounds about right; the others are 30 mm.

Thanks !!!!!!!!!!!!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New molding clips needed for 242GT [200][1980]
posted by  someone claiming to be timc  on Tue Dec 21 03:55 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.