Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2010

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Stuck by a pin? How to separate M46 bellhousing from engine block?

posted by  Gregg Shadduck on  Sat Mar 12 06:10 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Mar 7 12:10 CST 2014
[RELATED]

Thanks, Chris, for your encouragement with this divorce of aluminum bellhousing and steel pins.

One out of two usually sticks? well, I guess my situation is normal, for what that's worth.

I have supported the whole shebang of engine and transmission from an engine hoist, lowered onto many blocks to TRY to get it all leveled and evenly supported. I will try, try again.

But I do wish there was something I could HIT! :)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Stuck by a pin? How to separate M46 bellhousing from engine block?
posted by  Gregg Shadduck subscriber  on Thu Mar 10 00:05 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.