Volvo RWD S90-V90 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2008 S90-V90 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Roll-over valve position on 960? S90-V90

posted by  rafferd on  Sun May 15 15:11 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 21 11:10 CST 2014
[RELATED]

I noticed on the 93 960 that the ventilation hose rubber connector to the EVAP canister had split.
I cut off the split bit and reconnected the rigid ventilation hose.
So far so good.
Curiously, for a hose that carries gas fumes it was very clean and appeared to have white talcum powder in it!
I sucked on the hose expecting a mouthful of fumes but no, only a vague chemical whiff!
I would like to check the hose back to the tank, without spending the day under the car.
Does anyone know of the location of the roll-over valve and where the ventilation hose enters the tank filler?

Thanks again,

Dan






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Roll-over valve position on 960? [S90-V90]
posted by  rafferd  on Sun May 15 15:11 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.