Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

89 engine in a 86 200

posted by  Sumerduckman on  Sat May 28 08:02 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Aug 21 11:31 CST 2007
[RELATED]

Unless someone can come up with something different, I would think you would have to swap more than the distributor to make it run right. Since the 86's use a LH2.2 fuel injection controls with the Volvo/ Chrysler ignition systems and the 89's use the LH2.4 and the EZ-116k ignition, you should do one or the other. If you are using the original ignition setup, Volvo/Chrysler ICU and wires, you will have to use the 86 distributor. If you are still using the 86 LH2.2ECU, you would have to use the 007 AMM and the fuel rail with the '86 injectors and FPR. May also be some issues with the O2 and coolent temp sensors, but I am not sure.
--
Gary Gilliam Sumerduck VA, '94 940 na Regina 150k, '86 240 180k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 89 engine in a 86 [200]
posted by  ssct1y  on Fri May 27 17:34 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.