Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Torque value for motor mount to block connection 700 1990

posted by  squeaks on  Sat Aug 13 14:08 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Feb 19 20:10 CST 2008
[RELATED]

I couldn't find a torque value for the bolts that hold the motor mounts to the block. I used a box wrench and got it very tight, but I put a torque wrench to it and could turn it so easy I was afraid of stripping it. What torque value sounds good to use for block bolts.

A separate question, if I swap 2 connectors for the sensors on the intake side of the block, what is the worst-case scenario? I was relying on the fact that the connectors were shaped differently, but it seems 2 of them are the same. One connector could reach both sensors, the other seemed to only be able to reach one. Process of elimination helps, but I'm still concerned.

-Nathan







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.