Volvo V8 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2024

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

5.0 no pip when warm

posted by  wongg3 on  Tue Mar 27 13:00 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 21 20:12 CST 2014
[RELATED]

Hey all, I have been having a no spark issue, and I thought I'd run it by here to get some ideas. The engine is a Ford 5.0, 93 style.

The problem: The car dies after running for about 7-10 minutes from cold. At that point, there is no spark. It will just die.

I pulled codes, and the only relevant one is a code 14, for "intermittant loss of pip signal"

I removed the TFI module, and it tests ok with a multimeter. This was done while it was warm.

During this no spark condition, I get 8 volts on the pip signal tested at the TFI module while cranking. I am hoping this means that there is a pip signal being produced, but I'm not totally sure, since the book says I should get 3-6 volts.

I will try the "10 pin squeeze" to make sure those connections are solid.

Any other ideas?

Greg






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 5.0 no pip when warm
posted by  wongg3  on Tue Mar 27 13:00 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.