Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2007 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: Engine Stabilizer Mount - DIY job? 850 1995

posted by  someone claiming to be Nathan Berk on  Sun Jan 28 05:10 CST 2001 [RELATED]

Hey Terry,

I have a 1995 Volvo 850 Turbo.

About a year ago I replaced my engine stabilizer with the IPD upgrade.

It is a real simple procedure- I recommend it !

Go to the "volvospeed.com" site "bay13" reapirs and maintenance section- they detail the procedure.

If I recall, the steps are basiccally as follows:

Remove the bolt going thru the factory piece and use a hack saw blade to carefully cut thru the bushing ( carefull not to cut the brace).

Hey, its really simple - i did it in less than 30 minutes.

As far as it being stiffer - I do not notice anything negative at all- works great!

Best of all- the factory part seems to be a part prone to frequent replacement..Why not put in something that will last a bit longer?

Good Luck !





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine Stabilizer Mount - DIY job? [850][1995]
posted by  someone claiming to be Terry Haywood  on Sun Jan 28 05:03 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.