Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2005 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Any one tried heating up the bracket to replace top motor mount? 850 1995

posted by  Matt850 on  Wed Nov 13 14:50 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I just got a 1994 850 Turbo Wagon. The bushing was shot. I had a hard time getting the old one out. Managed to get the center part out with a air hammer. The rest I did by heating the bracket with a small torch and then using a chisel and hammer (a big hammer) and banged away until it finally pushed out. I think the big hammer was the key, but the heating may have helped.

The two-piece urethane bsuhing was a snap to install...almost too easy. I kept thinking I did something wrong.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Any one tried heating up the bracket to replace top motor mount? [850][1995]
posted by  someone claiming to be Yuri  on Mon Nov 11 16:02 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.