Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2007 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Volvo 940GLE/Injector Status Stays Open 900 1992

posted by  Chris Mullet on  Wed Aug 20 02:41 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:08 CST 2014
[RELATED]

"...After further dignosis we came to know that the Injector seems to be open all the while eventhough by right it should be close and open base on the signal from Radio Suppression Relay and ECU signal..."

The Radio Suppression Relay actually feeds a CONSTANT electrical signal to one pin on each injector. The other pin on each injector is wired to the ECU which controls the completed circuit back to ground - the duration of this completed circuit to ground varies, based upon engine demands that are determined by the reading of several sensors that measure things like engine temperature, load, RPM, etc.

So if you were to unplug the wires from an injector, you should be able to measure a steady 12v signal to one of the wire terminals. If the other wire (the one that runs to the ECU) measures constant continuity to ground, then that sounds like a problem within the ECU.

Is it just one injector staying open, or all four?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Volvo 940GLE/Injector Status Stays Open [900][1992]
posted by  Vijay6242  on Tue Aug 19 16:27 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.