Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2019 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Volvo 940GLE/Injector Status Stays Open 900 1992

That injection system is multi port and not sequential so it should have just one driver in the ECU, if it is permanently grounded you will see all the injectors on continuously. You can also have a situation where the injector ground wires have rubbed through to ground somewhere and are holding the injectors open. Honestly, it is rare but I have seen both scenarios, rubbed through harness and faulty ECU holding them open or on full time. I guess the quickest way to figure it out would be to pull an injector connector and see if one leg goes right to ground, if it does then pull the connector at the ECU and see if it goes away, if it does you have a fault in the ECU, if it does not then the harness is grounded somewhere. I have definitely had some funky 16V ECU's in the past, it would not suprise me to hear that the control unit is the cause.

Mark






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Volvo 940GLE/Injector Status Stays Open [900][1992]
posted by  Vijay6242  on Tue Aug 19 16:27 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.