Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

is there a 'rope trick' for removing the cam gear?? 700 1992

posted by  raidman on  Sun Jan 2 20:06 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Apr 4 22:17 CST 2014
[RELATED]

I removed the cam gear from the 'donor' head by drilling a small hole in the plastic rear cover for the timing belt, then sticking a large phillips screwdriver up against a flat part of the head and using my 'new' Snap-on 18" breaker bar. Had to place on the floor and step on it for leverage.
Now, how do I remove the bolt from the OEM cam gear that has probably been installed with an air impact gun?
I checked and an electric impact wrench will not fit unless I remove the fan, shroud and radiator.
I figure to use the Crank hold down tool (for changing the timing belt) to hold the belt and gears still, then try to remove the bolt with my breaker bar.

Any help would be great.
thanks,
el raidman






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED 1 is there a 'rope trick' for removing the cam gear?? [700][1992]
posted by  raidman  on Sun Jan 2 20:06 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.