Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2016 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Copper spray for head gaskets? 900 1993

posted by  1pocket on  Thu Mar 3 19:31 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

i must respectfully disagree. it is true the head warps only under duress from overheating.

nevertheless anything more than .005 gap if you run a machinists edge across the head and the new gasket won't hold well. if it were me i would run a steel edge across and diagonally and use feeler gauges to find out exactly where you are.

the most likely place to find a space will be in the very middle of the head.

cleanliness on head surface cleaning and block surface cleaning is critical for long term success. also make sure you have zero fluid remaining in any of the head bolt holes after removing the bolts.

a good shop vacuum running as you scrape the block surface clean keeps crap from getting into the rings.

do a search on trichard posts as i wrote up a long bullet point.. how to... on this job a while back.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Copper spray for head gaskets? [900][1993]
posted by  Wareagle32789  on Thu Mar 3 08:07 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.