Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

no start after engine work

posted by  lateshow on  Mon Jan 16 05:04 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jan 19 09:55 CST 2013
[RELATED]

just replaced the cylinder head with a used one (think the old one was warped)
but had trouble with timing belt. couldn't remove crankshaft pulley. so, although the camshaft and crankshaft were lined up on the money, I don't know for sure about the auxilary shaft. Is this critical? Why else won't it start?
Can smell gas ok, but seems like no spark. Should I pull a plug and look for spark arcing? What about that little black wire connector to the head(2 prongs inside)? maybe I got that on wrong. yikes!
'88 240 wagon B230F 180,000






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New no start after engine work
posted by  lateshow  on Mon Jan 16 05:04 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.