Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2009 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

760 ignition switch 700 1989

posted by  someone claiming to be steve mahnken on  Wed Sep 27 08:25 CST 2006 [RELATED]

My ignition switch in my 89 760 has failed and the key will not turn. I have reviewed the FAQ regarding switch removal but none of the instructions seem to address my configuration (even though they make direct reference to this model, it dosen't seem correct). I have the tilt steering wheel and the ignition switching is mounted on the yoke that the steering wheel is mounted to. This yoke is basically a one piece casting with the only visible interuption being what appears to be a roll pin mounted in the side of the cylindrical portion of the casting that houses the ignition switch. This pin is located directly behind the steering wheel.

My question is, can I drill out this pin to remove the switch or am I going to have to demo the switch to get it out?

Thanks

Steve






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 760 ignition switch [700][1989]
posted by  someone claiming to be steve mahnken  on Wed Sep 27 08:25 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.