Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2006 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Fuel pump sending unit install 700 1990

posted by  interstition on  Sun Dec 10 10:33 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Apr 28 10:13 CST 2014
[RELATED]

After hours of repeated trying, I'm out of ideas. I've read the FAQ and Art Benstien's excellent writeup, but I just can't complete the job.

Fuel sending unit is tied up with string through the vent hole so it is as short as it can get. Gasket and threads of cap ring are lubed. The sending unit is in the proper orientation (checked against my pre-install photo and the one's on Art's page) and I believe the bottom of the unit is in the cradle at the bottom of the tank as it should be. Yet, I cannot get the sending unit to go in quite far enough for the cap ring to catch on the the screw threads of the tank. Bifurcated gasket seems to be seating properly over the edge of the tank hole.

Any additional tips or encouragement would be much appreciated.
--
Andy in St. Paul - '91 745 218K mi, '91 745 210K, '90 744 189K, all Rex-Regina - past 240s






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fuel pump sending unit install [700][1990]
posted by  interstition  on Sun Dec 10 10:33 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.