Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

removal of intake to change head gasket '94' 940

posted by  troubles on  Fri Apr 27 18:04 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jun 25 14:05 CST 2008
[RELATED]

I read some past threads that suggest I can take the intake loose and just ease it away from the head and then pull the head. Also, would you recommend that I unbolt the lower timing belt sprocket and leave the one on the cam alone therefore pulling the cover up with the head (back of cover I mean). Some of you guys might think this one is slightly over my head and your probably right. I think it is too but I am bound and determined to do this job.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New removal of intake to change head gasket '94' 940
posted by  troubles subscriber  on Fri Apr 27 18:04 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.