Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Emiisions Question (lambda sond) and Hood Alignment 200 1984

posted by  jdm on  Sun Jul 8 13:12 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Apr 6 11:42 CST 2014
[RELATED]

All,

I am putting the emission control system on my (new to me) 1984 244, B21FT, auto trans back together. My question is this, I have installed a new pressure switch, it was totally missing and is located on the center of the firewall, it signals the ecu to hold the frequency valve duty cycle at a fixed setting during accelleration. There is a delay valve that should attach to the pressure switch, I have a new delay valve, which way is the valve oriented one side of it is yellow and one black and it seems to move air in only one direction. Any thoughts?

Second item, the rear of the hood is about 1/4" above the fender edge, the hood closes and latches tightly. Is this a bent hood or an alignment issue, and how do I correct it? As always thanks for any input.
Thanks,
JD





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Emiisions Question (lambda sond) and Hood Alignment [200][1984]
posted by  jdm subscriber  on Sun Jul 8 13:12 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.