Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rubber caps on the sides of vacuum tank 200

posted by  gopeshs on  Mon May 18 08:59 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon May 19 14:01 CST 2014
[RELATED]

I wanted to change the rubber grommets/caps which are on the sides of vacuum tank as well as on the valve which provides one way suction from the engine.
In my car they have started to leak , causing an air leak.


Is there any other alternative? it looks like a dealer only part,now the part might be cheap but dealer is far away. I tried epoxy putty to permanently set those tiny steel conduits in the tank (without rubber caps) but it did not work

Regards
--
DD-1990 240 DL SW M47II FI 3.1 234 K miles






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rubber caps on the sides of vacuum tank [200]
posted by  gopeshs  on Mon May 18 08:59 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.