Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

floor board wire way cover 200 1989

posted by  ACVOLVO on  Sat Apr 24 13:08 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Sep 19 13:15 CST 2014
[RELATED]

I have a question, I removed the carpet and drivers side front seat to repair s rust hole in the floor and run some speaker cable also. In the floor on the drivers side front there is a sheet metal cover you remove and there is the wire cables that run to the back of the car. The sheet metal cover is bent like an "L". Does any one know which way this sheet metal cover is suppose to go back?? Is the bent lip suppose to go towards the door or towards the gas pedal? any help would be appreciated.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New floor board wire way cover [200][1989]
posted by  ACVOLVO subscriber  on Sat Apr 24 13:08 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.