Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

91 240 Fault Code 4-1-3 200

posted by  joe_1991_240 on  Sat Nov 8 21:43 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

My newly acquired 1991 California 240 has a fault code 4-1-3, which is the EGR Temperature Sensor.

Where is it? [My Mitchell service manual suggests using an ohmmeter between terminal 22 and ground, looking for 500-550 ohms at 68 degrees F (1000 ohms for hot engine).]

Do I need to replace it, or is the car okay to drive? It seems to run fine, perhaps a bit cool. I discovered the blown-out CHECK ENGINE bulb when removing the temperature compensation board...

Thanks, Joe (Iowa)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 91 240 Fault Code 4-1-3 [200]
posted by  joe_1991_240  on Sat Nov 8 21:43 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.