Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Going to a shop 700 1988

uid 4791's pic
posted by  UncommonDenominator on  Wed May 15 03:26 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

OK...so i head to the shop to check out why my car makes the humming noises and the clunks when i slow down. I was hoping that i would just have a simple u-joint problem. Turns out i have to have the following replaced:
-bad right wheel bearing ($225)
-bad center drive shaft ($245)

Apparently all my noises where caused not only by these problems, but my rims in the front were bent. How do you get your rims bent???

Oh, well atleast i'm getting it fixed.

--
-Brandon at home '88 744ti 138k miles






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Going to a shop [700][1988]
posted by  UncommonDenominator  on Wed May 15 03:26 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.