Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2006

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

swapping camshafts

posted by  Bram Smits on  Tue Sep 24 10:26 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

B230F engines.

What's the list wisdom on using used heads with used camshafts? I'm in need of a new head (propane ate the valve seats, still that's not too bad at 211K mi), and I've got a good used head around. That head's from a 240 (block mounted distributor, M cam, no slots for the rear of head distributor), I'm driving a 940 (rear of head distributor, VX cam (230FB engine)).

So far I've only swapped in new cams (or new heads), will putting the VX cam from the 940 onto the 240 head (both used) likely work fine, or will it lead to rapid bearing wear?

Bram






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New swapping camshafts
posted by  Bram Smits  on Tue Sep 24 10:26 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.