Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Serious help with starting engine needed 700

Car is a 1988 UK spec 740 TIC with B230ET and M46, 292k miles. I have done a large service on my engine and now it will not start up properly. Here is what I have done:

Replaced inlet and exhaust manifold gaskets, distributor cap, rotor, leads, plugs, oil, coolant, all hoses, filter, turbo oil pipes, radiator, in tank pump, fuel filter, fuel pressure regulator and water pump. I also had the injectors cleaned professionally.

I have not managed to connect the turbo properly as I have mislead a few hoses so I have all hoses in place on the inlet side and the hose from the airbox to the turbo but nothing from turbo to intercooler. Will this work or will the AMM and the ECU go funny?

What happens is that the engine does crank and for a long while it almost starts but does not fire up, then I got it to run but only for a few seconds and it does misfire badly, then dies. Any ideas or should this run when I connect the turbo properly?
--
George Holmer, Belgium, Europe, 1987 745 GLE Turbo Diesel Intercooler (D24TIC/ZF22) 200k; 1988 745 Turbo Intercooler (B230ET/M46) 290k; 1988 745 GL (B200E/M47) 190k http://www.ttsservices.co.uk/my%20volvos.htm






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Serious help with starting engine needed [700]
posted by  gholmer  on Sat Jun 7 09:58 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.