Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Jacking point question 700

posted by  garlandw on  Sun Nov 9 11:03 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Sep 10 08:58 CST 2014
[RELATED]

I used the car jack to jack up the rear yesterday. I usually use my floor jack for such things but as I had the spare tire compartment open, I grabbed the car jack. I found, to my surprise that
a) The jack appeared to be not the original. The top point that meshes with the jacking point on the car didn't mesh properly and the crank handle didn't fit with jack! Glad I found out in my driveway.
b) The jacking point gave way a little when I jacked it up. THAT surprised me. The car is a near pristine 1990 745 with no rust at all that I can see. Surely the rocker panel area is not rusting out! The car is galvanized and hasn't seen all that many winters.

Anyone have a jacking point go on a clean 740?

Bill
--
Volvo Info Site 1990 745GLE 16valve






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Jacking point question [700]
posted by  garlandw subscriber  on Sun Nov 9 11:03 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.