Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2003 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Weber Conversion Question 120-130 1964

posted by  Tommy on  Sat Dec 27 13:11 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I just installed a used, but complete Weber DGV kit on my 122, but I don't have instuctions and I'm not sure how to connect the hot water hose to it. The kit came with a few fittings (a 1/4" restricter and a "T"), but not sure where these go. Does anyone have a picture of the setup or describe how to hook up the hot water lines? I've heard some say they've used the heater hose so that water only flows through the carb base when the heater is turned on. Sounds good, but if that's the case why would I need the "T" connector?
--
Tommy '64 122S







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Weber Conversion Question [120-130][1964]
posted by  Tommy  on Sat Dec 27 13:11 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.