Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2001 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

drive line vibe after clutch replacement-M46 700

posted by  jchiodi on  Thu Jul 1 02:24 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Feb 25 11:26 CST 2013
[RELATED]

Just replaced the clutch. After reassembly two issues.

At speed +20mph, I start getting a bad vibration from the driveline.

I had left the driveshaft together, and just dropped it down by taking off the center bearing support plate. The two piece driveshaft never came apart.

Do I have to align driveshaft with trans output flange?

Also, I'm looking at the rubber plate between output shaft of trans. and first section of driveshaft, and it doesn't look right. Not aligned correctly.

I don't remember exactly how they came apart, and I don't see any diagrams in the manual. I looked at it awhile, and thought I did it in the only way that it could go together, but I'm not sure now that it's right.

any help?

jc



--
1985 740gle na, 1990 740gle 16 valve






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New drive line vibe after clutch replacement-M46 [700]
posted by  jchiodi subscriber  on Thu Jul 1 02:24 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.