Volvo RWD 1800 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2001 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

D-type output flange 1800

posted by  someone claiming to be Al on  Tue Nov 2 00:19 CST 2004 [RELATED]

Does anyone know what the outside diameter of the shaft portion of a "d"-type output fange should be?

I rebuilt the unit (probably a '67) and it seeps oil from the output shaft seal. I don't think there were different size seals or flanges used and that leads me to believe that the flange may have been machined to a smaller diameter in a previous life. I don't know the history of this unit.

The flange I have has a 1.310" diameter. Should it be closer to 1.340"?

Other than the drip, the rebuild was a success.

Thank you for the help.

Al S.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New D-type output flange [1800]
posted by  someone claiming to be Al  on Tue Nov 2 00:19 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.