Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Getting M46 to go back on the engine 200 1984

posted by  smith_t240 on  Sat Jan 8 16:34 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Apr 24 02:21 CST 2007
[RELATED]

1984.5 B21FT M46 245 Ti

I CANNOT, for the life of me, get the transmission to fit back on the engine. I wrestled with it for 2 hours tonight and my dad and brother helped too. Exhaust is off. It just seems like there is not enough room in the transmission tunnel to get it to align right. If it isn't rubbing on the sides, the shifter brace on back is hitting the top. Its very hard to get the input shaft to get back through the pressure plate "fingers" and onto the splines by the pilot bearing. I just can't do it!!!!!!!

I have 2 floor jacks and helpers. PLEASE help!! I left the garage tonight very pissed off and frustrated and usually a little break always helps.

Any tips or pointers at all????

Later,
Smith






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Getting M46 to go back on the engine [200][1984]
posted by  smith_t240  on Sat Jan 8 16:34 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.