Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Can't separate control arm from bushing bracket 200

posted by  goldjimsberry on  Fri Jul 29 18:43 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Am I doing something wrong here? I removed the control arm and bushing bracket as a unit and can't get the two separated no matter how much I pound and pry. Is there some special technique I missed? Or am I slowly discovering I own the car with fused parts? (I'm also dealing with a siezed bolt in the ball-joint bracket that's going under the drill tomorrow.)

Any help would be appreciated.

And yes, I did remove the nut.

--
Jim - '92 Red 245 193K, and sometimes an '85 245 275K+






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Can't separate control arm from bushing bracket [200]
posted by  goldjimsberry  on Fri Jul 29 18:43 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.