The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rough idle....replace harness? 200

Hey rustydog...

Nothing I could see in the intake piping except the IAC hose that attaches to the large bellows head in front of the throttle body. Keeps wanting to pop off. But even when I hold it all the way down...no change.

Gaskets are new from FCP.

Thermostat assembly in airbox was removed including flap. Side preheat hose vent was covered with a very fine stainless steel mesh for more air.

Did botch up the ground connection for the ICU, but it's now grounded properly and so are the dual FI grounds on the intake. Will remove and clean again.

Throttle was cleaned with carb cleaner and those tiny little holes at the base were blown out. I was careful not to get any spray into the TPS. I will check the TPS again tomorrow.

Which leaves me with the harness. Have a spare FI harness but no ignition one.

Did you remove the fan shroud, belly pan or both to snake the harness under the engine???






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.