Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rough idle....replace harness? 200

posted by  zima on  Fri Jul 13 15:04 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Nov 3 20:02 CST 2011
[RELATED]

Hey rustydog...

Nothing I could see in the intake piping except the IAC hose that attaches to the large bellows head in front of the throttle body. Keeps wanting to pop off. But even when I hold it all the way down...no change.

Gaskets are new from FCP.

Thermostat assembly in airbox was removed including flap. Side preheat hose vent was covered with a very fine stainless steel mesh for more air.

Did botch up the ground connection for the ICU, but it's now grounded properly and so are the dual FI grounds on the intake. Will remove and clean again.

Throttle was cleaned with carb cleaner and those tiny little holes at the base were blown out. I was careful not to get any spray into the TPS. I will check the TPS again tomorrow.

Which leaves me with the harness. Have a spare FI harness but no ignition one.

Did you remove the fan shroud, belly pan or both to snake the harness under the engine???






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Rough idle....replace harness? [200]
posted by  zima  on Thu Jul 12 11:42 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.