Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2007 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Any front cam bearing problems? 140-160

posted by  walrus3 on  Mon Nov 7 14:28 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 2 14:20 CST 2013
[RELATED]

There are a couple things about installation that can mess you up.
One is if the oil holes are not aligned right, you don't get lube to the
bushing.
The other one is that if it is pushed in too hard and/or not quite straight,
the bushing can buckle a bit and be too tight. This becomes more likely if
you got it in wrong first (see above), then push it out and push it in again.

I have seen both of these happen.
The bushing is oiled from the center oil passage so the oil squirter
is not a factor in THIS failure but can certainly cause other failures.
--
George Downs Bartlesville, Heart of the USA!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Any front cam bearing problems? [140-160]
posted by  uniberp  on Mon Nov 7 07:12 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.